Vacuum cart ID:134

From Protospace Wiki
Revision as of 10:52, 1 February 2019 by Cjs (talk | contribs) (updated image link)
Jump to navigation Jump to search

← Back to tools we have

134.jpg
Type Vacuum Cart
Make/Model DIY
Serial number N/A
Original owner Janet M
Loan status Semi-Permanent Loan
Arrival date 2014
Location Mobile, Woodshop
Functional status Working
Usage permissions Open to Members
Certification Demo Required
Wiki-ID 134
Label 1.0" 1.5" 2.0"


Usage Notes

  • Uses vacuum pump to create powerful vacuum, slowly.
  • Stores vacuum, optionally, in two 14" diameter storage tanks, takes several minutes to charge.
  • Cart contains vacuum degassing chamber, to remove bubbles from fast setting epoxies
  • Ball valves allow vacuum to be dumped from the storage tanks into the degassing chamber instantly.
  • Has small vacuformer (6 inch x 8 inch)
  • Plans for full size vacuum bed with infra-red bulb-based plastic heater above.
  • Mates with 8' vacuum cannon accessory too.
  • Doesn't like to run without resistance.
  • There should be a minimum 5:1 ratio of liquid you are degassing to chamber size (the amount you're degassing is no more than 1/5 the size of the chamber).
  • Try to avoid degassing anything that will boil under vacuum at 20 degrees Celsius (this includes water) as it will contaminate the oil in the vacuum pump. This is because we are not running a cold trap like a fancy laboratory.
  • Other than that its pretty much mechanically self explanatory, the two large tanks are there so you can pre vac them out and use them to pull the chamber down quickly if you have a fast setting resin.

Specs